Charflame fireproof coating is supplied ready to use. Mix mechanically thoroughly before applying the coating. Airless spray is the recommended method of application, although a brush or roller may also be used for small areas or repairs. Clean with only water and do not use solvents. Under Y type environmental conditions, Charflame fireproof coating can be covered with the topcoat specified in the ETA. The coating must be complete and the Charflame Reactive Coating must be completely dry and cured prior to application of the topcoat. Protect Charflame fireproof coating from strong gusts of wind and high temperatures during application to avoid quick and incorrect drying. Under these conditions, small coatings are recommended. The drying time depends on the atmospheric temperature, the temperature of the steel and the air movement that occurs. The coating dries quickly because it is water-borne. An additional coat is recommended the next day. The surface temperature must always be at least 3 ° C above the dew point temperature. Avoid application where there is any risk of condensation on the steel surface. Adequate ventilation is recommended.